Jack Wyse

• Five years of hands-on experience, completed through a full-time apprenticeship with Welfab Engineering
• Extensive onsite and workshop experience with high-purity Biobore, carbon steel, and stainless steel piping systems
• Skilled in cutting and preparation of fittings according to technical drawings and specifications
• Competent in fabrication and fitting of carbon and stainless steel pipes ranging from ½ inch to 44 inches in diameter
• Fabricated double contained stainless piping systems up to 14 inches in diameter
• WELDING EXPERIENCE* Proficient in MIG, TIG, and stick welding techniques for heavy equipment, pipelines, and structural components used in mining operations.
  * Skilled in reading blueprints, interpreting welding symbols, and adhering to industry codes and standards (e.g., AWS, ASME).
  * Experienced in welding various metals, including carbon steel, stainless steel, and wear-resistant alloys, commonly used in mining equipment.
  

• Inspection: Check the flanges for any damage, such as cracks, dents, or corrosion. Make sure the flange faces are clean and free of debris.
• Cleaning: Clean the flange faces with a wire brush or appropriate solvent to remove any dirt, rust, or old gasket material.

2. Gasket Selection:

• Compatibility: Choose a gasket material that is compatible with the fluid or gas being transported and the operating temperature and pressure.
• Type: Select the appropriate type of gasket (e.g., full-face, raised-face, ring gasket) based on the flange type and application requirements.
• Size: Ensure the gasket is the correct size for the flange.

3. Alignment:

• Proper Alignment: Align the flanges so that the bolt holes line up correctly. Use flange spreaders or jacks if necessary to achieve proper alignment without damaging the flanges.
• Parallelism: Check that the flange faces are parallel to each other. Misalignment can cause uneven gasket compression and lead to leaks.

4. Bolt Installation:

• Lubrication: Apply a lubricant or anti-seize compound to the bolt threads to ensure proper torque and prevent galling.

HYDRAULIC AND WATER PUMP EXPERIENCE

1. Preparation:

• Isolate the section of the hydraulic system to be tested.
• Fill the system with a testing fluid (usually hydraulic oil or water with a corrosion inhibitor).
• Remove any air from the system to prevent inaccurate readings and potential hazards.

2. Applying Pressure:

• Connect a pressure testing pump to the isolated system.
• Gradually increase the pressure to the specified test pressure, which is often higher than the normal operating pressure (e.g., 1.5 times the operating pressure).
• Monitor the pressure using a calibrated pressure gauge.

3. Inspection:

• Hold the pressure for a set period (e.g., 15-30 minutes).
• Inspect all connections, joints, and components for leaks or signs of deformation.
• Check for any pressure drop, which could indicate a leak or system weakness.

4. Documentation:

• Record the test pressure, duration, and any observations.
• Document any leaks or failures and the corrective actions taken.

WELDING EXPERIENCE

• * Proficient in MIG, TIG, and stick welding techniques for heavy equipment, pipelines, and structural components used in mining operations.
• * Skilled in reading blueprints, interpreting welding symbols, and adhering to industry codes and standards (e.g., AWS, ASME).
• * Experienced in welding various metals, including carbon steel, stainless steel, and wear-resistant alloys, commonly used in mining equipment.

Assisted in maintaining and repairing hydraulic farm equipment to support optimal functionality. Fixed gears on tractors to enhance operational efficiency.